one.A connecting link of an O-ring Chain for standard application is pre-coated with grease in the pins. In advance of connection, confirm the grease around the surfaces of pins, and if the volume of grease is little, apply grease with bare hands. (If gloves are used, the grease are going to be absorbed by the gloves.)
Instance: When the connecting link (I) of an O-ring chain for standard application is
shipped, O-rings are fitted on the roots of the pins. In the event the O-rings come loose resulting from vibration during transport, refit the O-rings in on the roots of your pins.
In this instance, you’ll want to return the grease collected in the roots of the pins to the central surfaces of your pins, much more at portion A than at portions B shown while in the above illustration. (Portions A is worn as a result of sliding with all the bushings.)
two.The chain is often most conveniently connected about the teeth of the sprocket. Engage the back links at the two ends of your chain using the sprocket teeth and match connecting pins. If the sprocket could be moved, the chain may also be linked about the loosened side.
3. Connecting procedure
1.Confirm that O-rings are attached to the roots of your pins.
2.If your volume of grease utilized around the connecting pins is little, coat the pins with grease in the central portions.
3.Insert the connecting pins in to the bushings of your inner back links at each ends.
4.Confirm the grease is 
applied towards the complete encounter of the O-ring, and fit the O-ring onto the connecting pins.
5.Insert the connecting pins to the connecting plate and although pressing the connecting plate, set up the spring clip. Verify whether or not the head (the finish without a split) of the spring clip is turned in the feeding route of the chain. (See the following illustration.)
6.Be sure you verify the spring clip is securely fitted inside the clip grooves of your connecting pins.
This completes jointing with the connecting hyperlink. Note that grease over the surfaces of connecting pins and O-rings may be removed all through set up get the job done. In this case, re-grease using the grease to the surface with the base chain or the grease from the polyethylene bag through which the connecting link was contained.