one.A connecting hyperlink of an O-ring Chain for general application is pre-coated with grease with the pins. Prior to connection, confirm the grease over the surfaces of pins, and when the quantity of grease is small, apply grease with bare hands. (If gloves are used, the grease are going to be absorbed through the gloves.)
Instance: Once the connecting website link (I) of an O-ring chain for common application is
shipped, O-rings are fitted on the roots from the pins. If your O-rings come loose due to vibration in the course of transport, refit the O-rings in to the roots of the pins.
In this instance, make sure to return the grease collected at the roots with the pins towards the central surfaces on the pins, additional at portion A than at portions B proven during the above illustration. (Portions A is worn because of sliding with all the bushings.)
two.The chain is often most effortlessly linked within the teeth of the sprocket. Engage the hyperlinks at each ends of your chain with the sprocket teeth and match connecting pins. In the event the sprocket could be moved, the chain can also be connected within the loosened side.
3. Connecting procedure
1.Verify that O-rings are attached to your roots from the pins.
2.In the event the amount 
of grease utilized around the connecting pins is compact, coat the pins with grease on the central portions.
3.Insert the connecting pins into the bushings on the inner hyperlinks at both ends.
four.Verify that the grease is applied to the total face of your O-ring, and fit the O-ring onto the connecting pins.
5.Insert the connecting pins into the connecting plate and although pressing the connecting plate, install the spring clip. Confirm no matter whether the head (the end without a split) from the spring clip is turned while in the feeding route of the chain. (See the following illustration.)
six.Be sure to verify that the spring clip is securely fitted within the clip grooves on the connecting pins.
This completes jointing of your connecting website link. Note that grease on the surfaces of connecting pins and O-rings may be removed through installation perform. In this instance, re-grease utilizing the grease on the surface of your base chain or the grease from the polyethylene bag during which the connecting hyperlink was contained.